If youre like me, you might have 1 or 40 of those used dab cartridges just lying around your house WELL, if you also just so happen to have 800-1000mg of DMT and a couple drops of Propylene Glycol, YOURE IN LUCK! Procedure as follows


*Things you will need*
800-1000mg of N-NDMT
a couple ml of PPG
Spent Cannabis Distillate cartridge
Small microwaveable glass bowl
Paper towel or towel for drying bowl

PREPPING THE USED CARTRIDGE
Most cartridges have a screw-off mouth piece and are filled via the exposed glass tank beneath, so to start, remove this mouth piece and allow the cartridge to sit upside down for a couple hours, draining away any excess leftover distillate. After all visible distillate has drained from the tank, pour approx 1ml of PPG into the cartridge, screw the lid/mouthpiece back on, and vaporize the PPG with "mouth hits" until you can no longer taste terpines from the distillate.The mouth hits will also give you an indication to what condition your coil is in too. (Remember, most of these cartridges are meant for single use and then designed to be thrown away, so if you have multiple cartridges you might want to clean them both and decide which one seems to be in better shape.) Take the mouthpiece back off, and allow all of the PPG to drain out of the tank and you now have a clean Vape cartridge ready for re-purposing.

IF YOU DONT HAVE A WAY OF WARMING YOUR PPG IN A CONTROLLED AND MONITORED WAY START HERE:

fill your bowl up with water and microwave it until the bowl is hot to the touch but still able to be handled (approx 140 F if you have a thermometer) Then pour the water out of bowl and dry it with your paper towels making sure there is no left over moisture from the water. Quickly add half a Ml of PPG and then your DMT. the warmth of the bowl should help dissolve the DMT with the PPG into a beautiful, clear, bright yellow, runny wax that is now ready to be added to your recycled cartridge. mix using something small, such as a paperclip or the tip of a small knife.

STEP 1
In a small bowl mix half a ML of PPG with 1000 mg of DMT, warm the mixture to approx 130 degrees F, stirring or swirling constantly. CAREFUL NEVER TO EXCEED 140 F

STEP 2
Remove the mouth piece from your recycled cartridge and then Using an eye dropper or syringe, Collect the DMT from the bowl and carefully dispense it into your empty glass vape tank.

STEP 3
screw the lid/mouthpiece back on and check to make sure that your coil is still making a proper connection with your battery, if everything seems to be working properly, you are ready to go! Ive found that 10-12W (4.2v) seems to give me the most potent yet smoothest hits. Two-Three hits on average for breakthrough dosage at the listed potency. Peace, Love, Cheers, all of that. Any thoughts, comments, or queries are welcome and encouraged.

Thanks friend! This comes soo in handy

You are more than welcome!