DMT-Nexus member
Posts: 595 Joined: 19-Aug-2009 Last visit: 30-Apr-2011
|
The first pull didn't yield much of anything, but that seems to be due to a lack of proper vortexing of the limo/vinegar. Luckily, all the limonene was saved for just such an eventuality.
|
|
|
|
|
DMT-Nexus member
Posts: 106 Joined: 08-Feb-2009 Last visit: 12-May-2018 Location: N. America
|
if one were to run it through a few more times than suggested and cleaned up a little bit more, could this method be used as quantitative extraction?
|
|
|
DMT-Nexus member
Posts: 595 Joined: 19-Aug-2009 Last visit: 30-Apr-2011
|
Evaporating the vinegar: -Has it ever been determined at what temperature mescaline acetate is destroyed or made inactive? Vinegar boils at just a touch above 100*C.
Limonene conservation: -Could used limonene be distilled in a normal pot still and used again? Is there any loss of effectiveness possible, perhaps by distillable contaminants?
|
|
|
DMT-Nexus member
Posts: 4804 Joined: 08-Dec-2008 Last visit: 18-Aug-2023 Location: UK
|
I prefer not to use too much heat at all when evapping vinegar pulls. Comparative assays on the same batch of cactus have shown that the heated pull was less effective.
Distilling limonene can ve very useful. As you can easily distil it using just hot water as a heat source it's very unlikley that anything else in the limonene will be ditsilled over as well. Limonene is slightly vollatile and to the best of my knowledge, the impurities in cactus are not.
|
|
|
DMT-Nexus member
Posts: 595 Joined: 19-Aug-2009 Last visit: 30-Apr-2011
|
Thanks for the info, soulfood. This is crazy frustrating, hearing from SWIM about a plate of goo that won't dry out. He's tempted to just toss some 5-htp in there for texture and toss it in gel caps and just be done with it.
|
|
|
DMT-Nexus member
Posts: 103 Joined: 08-Aug-2009 Last visit: 05-Jan-2011 Location: Pacific Northwest
|
Don't get impatient. I passively dry my vinegar with heat, by placing it on top of a toaster oven. On the lowest settings it cycles on for 30sec-1min every few minutes. I actually turn the heat way up during the beginning, and then lower it once the vinegar starts getting thicker. My evap plates are usually dry withing 12 hours. Now as to potential potency loss I can't attest either way. I feel that my mescaline is of average potency as 300mgs of acetates was a full psychedelic experience, and after purifying my acetates I'd estimate that the 300mgs was more like 200mgs HCl. I don't know why heat would be a big issue since mescaline hcl is pretty heat stable, and acetic acid evaporates along with the water preventing too much "acid burn." But that's just my thoughts, experiment for yourself and add to our data!
|
|
|
DMT-Nexus member
Posts: 595 Joined: 19-Aug-2009 Last visit: 30-Apr-2011
|
I guess it wouldn't be too much for some brave soul to dissolve 400mg in vinegar, and slow-evap half while boiling down the other half. Take the doses a few days apart and compare effects.
|
|
|
DMT-Nexus member
Posts: 198 Joined: 04-Mar-2009 Last visit: 27-Sep-2015 Location: That Great Gig in the Sky
|
Im sure this has been asked before, but can I use baking soda to freebase? By allowing this message to pass through your cornea, into your retina, you accept it as is and agree to my disclaimer regarding my posts that they are a complete falsification by doing so freeing me of all liability, direct, indirect, consequential or incidental that may arise from the instillation of this post in your memory bank.
|
|
|
DMT-Nexus member
Posts: 595 Joined: 19-Aug-2009 Last visit: 30-Apr-2011
|
Fatcat wrote:Im sure this has been asked before, but can I use baking soda to freebase? Nope. Look for Mrs. Wages Pickling Lime. In the canning section, if you can find a store that has it.
|
|
|
DMT-Nexus member
Posts: 222 Joined: 02-Feb-2009 Last visit: 07-Oct-2010 Location: North pole
|
Quote:Im sure this has been asked before, but can I use baking soda to freebase? Yes if you make soda ash from it.
|
|
|
DMT-Nexus member
Posts: 4804 Joined: 08-Dec-2008 Last visit: 18-Aug-2023 Location: UK
|
dread wrote:Quote:Im sure this has been asked before, but can I use baking soda to freebase? Yes if you make soda ash from it. While this is true, pickling lime (CaOH) is much more effective because it breaks down the cactus tissue way more efficently than Calcium carbonate.
|
|
|
DMT-Nexus member
Posts: 103 Joined: 30-Mar-2009 Last visit: 23-Jan-2021
|
soulfood wrote:Distilling limonene can ve very useful. As you can easily distil it using just hot water as a heat source it's very unlikley that anything else in the limonene will be ditsilled over as well. Limonene is slightly vollatile and to the best of my knowledge, the impurities in cactus are not. Elaboration on this method perhaps? Thank you much.
|
|
|
DMT-Nexus member
Posts: 198 Joined: 04-Mar-2009 Last visit: 27-Sep-2015 Location: That Great Gig in the Sky
|
thanks guys, I will look for that pickling lime By allowing this message to pass through your cornea, into your retina, you accept it as is and agree to my disclaimer regarding my posts that they are a complete falsification by doing so freeing me of all liability, direct, indirect, consequential or incidental that may arise from the instillation of this post in your memory bank.
|
|
|
The Amazing Me
Posts: 73 Joined: 30-Aug-2008 Last visit: 08-Mar-2012 Location: US
|
my local kroger has it for 3.79 +tax Recently released from a Psychiatric Hospital, Don't believe anything IT says.
|
|
|
DMT-Nexus member
Posts: 27 Joined: 13-Mar-2008 Last visit: 28-Mar-2013
|
swim has just done his first extract using this tek. His final product has come out in a slightly tan, kinda clumpy powder. There was no crystal formation on the evap dish. J/w if this is actually mesc acetate? It smells like vinegar. Will ingesting this produce the desired effects? thanks.. Matt
|
|
|
.
Posts: 6739 Joined: 13-Apr-2009 Last visit: 10-Apr-2022
|
So Matt what are the desired effects?
IT'S MESCALINE! :]
Gobble it down and have a wonderful day!
|
|
|
DMT-Nexus member
Posts: 27 Joined: 13-Mar-2008 Last visit: 28-Mar-2013
|
lol thanks, see you in the other dimension!
|
|
|
DMT-Nexus member
Posts: 27 Joined: 13-Mar-2008 Last visit: 28-Mar-2013
|
update: so last night swim took 300mg of the tan powder, and got nothing except a slight body buzz. No visual effects were noticed. Is the final product not pure enough? Does hot sauce react with mesc acetate? Swim ate taco bell about 20 mins before ingesting the mesc. JW why the final product did not produce the desired effects. Should swim try to re-xtal the tan powder in vinegar?
|
|
|
DMT-Nexus member
Posts: 595 Joined: 19-Aug-2009 Last visit: 30-Apr-2011
|
matttheazn wrote:update: so last night swim took 300mg of the tan powder, and got nothing except a slight body buzz. No visual effects were noticed. Is the final product not pure enough? Does hot sauce react with mesc acetate? Swim ate taco bell about 20 mins before ingesting the mesc. JW why the final product did not produce the desired effects. Should swim try to re-xtal the tan powder in vinegar? If it was clumpy and smelled like vinegar, it may not have been dry. SWIM noticed that a little bit of heat (hairdryer) made the tar-like stuff a little more gooey or liquid, and after stirring it around it was drier when it returned to room temp. No idea if the heat affects potency though
|
|
|
DMT-Nexus member
Posts: 27 Joined: 13-Mar-2008 Last visit: 28-Mar-2013
|
it was processed in a food dehydrator. it is a fine powder after you break up the clumps. idk maybe he justs need a higher dose. Swim usually eats about 4-5g of mushrooms or 3-4 hits of lsd to get where he wants to be.
|