Entheogenerator wrote:When it comes to measuring doses, your best bet when working with tinctures would probably be to use careful measurement. Dissolve a measured amount of DMT into a measured amount of alcohol (say 10mg per 1mL alcohol, just as an example). This way, it is easy to measure out an accurate dose (2mL = 20mg DMT).
Personally, I wouldn't smoke the two drops of concentrated DMT solution simply because the dosage is unknown. It could be 2mg, it could be 20. But that is obviously your call to make.
One half ounce of grain 190 proof alcohol ..
[with 3 or 4 grms of acacia crystals ]..shouldent take more than 5 hours at 80 degrees to evaporate..
[3 or 4 grams of acacia crystals were mixed in half ounce of G alcohol]
After 5 hours it apeared like melted crystals..[ a puddle of amber oil]...
Most of the alcohol was gone but it still smelled some of some alcohol in it..
After all night .. it dryed much more to a beige putty or waxy substance..
And it was potent!! and good!
I dont know why i wanted to do a carbonate wash?
..i was very carefull to let it seperate compleatly before each pull..
Seperation only took about 20 to 25 minutes each and it was clear but with a yellow tint no emulsion at all!..
I was heating ..shaking..and re heating my jar before each pull..the heat in bath caused it to pull fast and seperate fast...
I hope 20 minutes is long enough to let it seperate...
I was only concerned about posibile trace amounts of lye in the pulls..