I got interested in taking psychedelics about a year ago. I have finally gotten around to smoking DMT and I have been excited to do so.

I have built the machine vaporizer out of a glass soy sauce bottle. I drilled a hole on the bottom of the bottle and I'm using some rubber tubing to inhale from. Below is a link to some images of the vaporizer I have built.

I have not had any success vaporizing DMT with it. The first problem I have had is getting the DMT onto the wire mesh. A third of the DMT is falling through the mesh onto the table. I feel as if the mesh isn't thick enough because the neck of my bottle is too narrow. I have tried smoking DMT three times with it, and only a small amount of smoke has been generated. I think the problem is the bottle, the neck seems to narrow. I would like to know what you think and if you have had any success vaporizing from a bottle with such a skinny neck. Let me know if there is any hope for the vaporizer I have made. If the bottle is the problem I would like to hear suggestions on picking a new bottle.


http://dayviews.com/debo21/2014/6/15/ <------- Pictures

This bottle is way too big.

And then I absolutely don't get why people are using bottles. Doesn't make any sense to me.
Just get a steamroller pipe and fill the head up with wire mesh. Then use a torch lighter to heat it up carefully. Works like a charm. And a pipe like that is maybe $10 or so.

Get a Hennessey shot bottle and use that. Follow instructions in the wiki here. Put copper mesh or steel mesh in the neck of the bottle. Roll some up stuff it in and use something to push it tight then leave a little room to drop the DMT in. Use a flame to feather the neck and melt the DMT into the mesh. Don't get it to hit or it will burn. Just keep applying heat a little at a time and you'll see it start to melt.

Search here there's a whole thread about it. Its super simple you need the mesh tight enough to where you can pull air through it easily just pack it in. I usually out my finger over the mouth and use a pusher to tighten it in. Then back it up a little leaving a recess so the DMT can be placed in to pre.melt it.

Use search and read the FAQ and wiki it will tell you everything. Its not as hard as people make it seem. Just load it and smoke it don't pull the flame all the way into the mesh just enough so it touches the mesh or heat the glass.

You'll get it. But I'd tell you first thing is to drop that bottle and get a single shot bottle. Hennessey because it has a recess in the bottom and you can easily make s whole even by tapping it with a screwdriver.

First things first, please edit your post and remove the mention of purchasing DMT. Then, please read the Attitude Page in its entirety (not just the part I'm about to quote) before continuing to post on this forum.

I swear if I had a dollar for every time I have reposted the above paragraph, I would be a wealthy man.