I've seen quite alot of proposed Bufo extraction TEKS round here,
but many of them use chemicals I wouldn't know where to obtain or
chemicals that are rather expensive.(Fumaric acid, IPA, Ethanol, Xylene, DCM, MagnesiumSulfate..etc)
My cat is looking for a way to extract 5-HO-DMT from Cebil(A.Colubrina) seeds, using
more easily available & cheaper chemicals.(limited budget)
What's available & affordable around here:As far as I know 99% pure acetone(dry nuff?),Citric acid, Lime(Calcium Hydroxide),
Naphtha, Lye & SodiumCarbonate are all easily available and relatively cheap at
Dutch suppliers. (I suppose it's possible to make one's own Ethanol using Sugarwater, yeast & a simple destillation apparatus without spending alot of money, but would it be pure enough for extraction purposes?)
With these Chemicals I just mentioned my Cat could perform this proposed Tek:
69ron wrote:Acetone Citrate Bufotenine Precipitation Tech
* Coarsely grind 100 grams of Vilca seeds.
* Add 1 part pickling lime (calcium hydroxide) and mix in enough water to make it wet. NOTE: sodium carbonate works as a substitute for lime in all steps of this extraction tech.
* Mix for about 10 minutes and let it dry completely. There must not be any water present at all before going to the next step.
* Dissolve the mix in 500 ml of dry acetone. Filter out the solids. Repeat with more acetone until the acetone is nearly clear.
* Evaporate the acetone down to about 100 ml.
* Add 10% citric acid solution to the acetone until no more precipitation is seen. It will take about 30 ml of 10% citric acid solution for 100 grams of seeds. NOTE: to make the citric acid solution, dissolve 10 grams of citric acid in 100 ml of dry acetone. I will take a while for the citric acid to dissolve in the acetone, so prepare this solution several hours ahead of time.
* Carefully pour out the acetone leaving behind the precipitates. Discard the acetone.
* Dry the precipitates completely leaving crude bufotenine citrate and other junk. Bufotenine citrate is a goo and not very active. You don’t want it in this form.
* Slowly mix in lime until the goo becomes a dry powder. Then add water to make the mix wet and mix for about 10 minutes and let the mix dry completely. There must not be any water present at all before going to the next step.
* Grind the mix to a powder. Dissolve in 100 ml acetone and filter out the solids. Repeat with more acetone until the acetone is nearly clear.
* Evaporate the collected acetone to get nearly pure freebase bufotenine.
Has anyone have any success using this TEK yet? Or is it a no-no?
If it works I would like to hear it. If it doesn't, I would like to
hear another tried & tested Bufo Extraction from Cebil-Tek that
requires only the chemicals that are available in Holland(which I just mentioned)
Anyone?
PS: If anyone here knows Dutch suppliers of Xylene, DCM, IPA, Fumaric Acid, do enlighten me.