Hi all!!

I have just got one of these... (a glorified bulb pipe/vaporizer)

http://www.marketplace-b...b246a3.image.300x186.jpg

I've only used it once but didnt get a good hit. I put 60mg DMT into the bulb and heated slowly with a normal lighter until the DMT melted and then started to release vapor, I got a good lung but didnt get anywhere (same DM that I always use with success).

I'm a pretty inexperienced user of these so not sure whether I'm getting it right... any ideas??

Are you using a torch lighter with that? If not get one, its much easier to controll the heat with a torch.

But in all honesty, ban the bulb, they are a waste of DMT. Get a bong and enhance some leaf, or get a VG/GVG and say goodbuy to days of having difficulty vaping Spice.

the bulb is not good in my opinion.

Buy a GVG or...

Buy a Bong and a vaporstar. <- that is what i use.

Make a sandwich: little bit peppermint at the bottom-dmt-peppermint at the top.

now u put water in the bong and use a torch lighter.

this combination is a very smooth combination. You can hold the smoke for a long time and you can smoke all the dmt with 1 hit.

This will give you a breaktrough every time

Does the water not have nay effect on the smoke? And can you just put pure DM in?

there is maybe a little loss but that dont matter in my oppinoin because you can hold more dmt as without water.

you can put pure dmt in the vaporstar (peppermint-pure dmt-peppermint)

if you dont have peppermint you can also add oregano and that stuff

Cooling the vapour too much can be problematic and causing spice vapour to condense inside the bong, id be inclined to go without if possible. Assuming its vaporised properly and not burnt you shouldnt find too much trouble with harshness of the vapour but that all depends on you and what waterpipe you're using.

You will still need to take some measure to stop the DM running down the pipe as it becomes liquid before vaporising - such as the aforementioned sandwich using peppermint or putting a bed of ash under it