Hey you guys, I made a sort of DMT pipe with a mouth piece and bowl piece from another pipe. Just wondering if you guys think it would work. It successfully vaporised weed. And I have confirmed that no flame comes out the end just heat.

The only problem is the metal container gets reaaaaally hot! I got a blister from it.



What do you think? reckon it'll work, or will I just waste some precious dmt?

fun project!

almost anything will work, as long as the heat source does not burn the spice and vaporization occurs.

what i would do is get a small stone; similar to a Health Stone Glass piece. the HSG is too big for the pipe you made, but there are other things available (aquarium filter pieces, etc...) and melt the spice onto the stone and then place in the bowl.

it would probably work really well then - using it as is would be, pardon the pun, hit and miss...

Easiest way to melt spice onto there?

place stone on scale - note weight - do not tare

add spice to top of stone, calculating weight of spice+stone

(most milligram scales are more accurate in higher ranges, not in the lowest range...therefore a more accurate reading as in: stone=760mg+20mg spice = 780mg total) trying to weigh 20mg (on most scales) will be off by as much as +/- 5mg starting from zero)

place the stone with spice on a glass or marble surface and heat *from below* with a torch lighter from a distance - not from above. the stone will warm and the spice will melt into it. if you heat from above you run a great risk of burning the spice in an instant and POOF it's gone, or your dose is now way off.

place the stone in pipe and heat with torch lighter from a distance until vapor happens.

then, you know what happens...

hope this helped.