Did a extract of 100g MHRB, last two times ive had allot of fat in it so I did a mini A/B after. But I think I have been using to high temp, so more fat. This time i kept the water bath at 50C.

Anyhow, I did 6 pulls on the mini A/B. And the result got milky white in the pyrex dish and now in freezer. However the Mini A/B base soup is still milky, and once it cooled down allot fo white stuff seem to solidify and fall to the bottom.

This gotta be spice right?

Last time I did a mini A/B the base soup was almost clear after 5 pulls. I am curious as to how much I will have from the freezer tomorrow?

Could this be something else than spice im seeing? By the way, Im using Cybs salt hybrid tek.

I ran out of time so I stopped at 6 pulls, had planned to drink aya tonight (which I just did)

Just warm it up again and do another pull when you get the time, if there is DMT in there it'll migrate to the solvent. If not its probably spent. 6 pulls is usually pretty thorough. I generally find 4 is enough for me before it becomes fruitless.

I've seen a white precipitate fall out to the bottom of the vessel before, it wasn't DMT though. Couldn't identify it. You could break it up though by warming the soup.

I think you are right, there was 2.2 g of yellow fluff/goo from 6 pulls.

But I dont get why I get so much fats with, even after a mini A/B.

Is it my MHRB that is extra ¨fatty", its the third extract of the same bar with similar result.

Trying now with some powdered ACTB.

I plan to use this for Changa anyway, so the yellow goo should be good right?

Possibly old bark or too much heat.
Try a few re-x`s with warm solvent.
If the yellow comes over, the solvent is too warm.
It should pick up white & leave a yellow blob at the bottom, but you can work with small amounts (10ml) at a time to slowly pick up the white spice from the yellow oils without pulling too much into it.

Thanks I ended up dissolving it in alkohol and add it to changa mix. 2.2 g leaves (Caapi and lemon balm) and 500 mg harmala freebase.

I´m doing another extract now with ACTB. Interestingly the naptha was more yellow, but after back-salting it is perfectly clear. The pulls with the mini A/B are clear as mountain water.

I think i might have been using too much heat when pulling, and too little heat when back-salting.

But I also think the MHRB was especially ¨fatty¨, make a very good Aya analog though

My rule of thumb with heat is this...if it's that hot that you can't hold the vessel with your hands then its too hot. It only needs to be 40-50degrees, doesn't matter if it gets a bit colder just reheat it a little but no need to boil the life out of it.