greets to everyone

ive had performed successfully 2 extractions of white pure dmt xtals but now im intrested on a new extraction of junle spice using cybs stb tek and i have several questions before i start because i have not found information that suits me, i had just found vague information about it like just change naphta for toluene, so for me the thing goes like this:

1.- i will perform cybs hybrid tek and will change naphta for toluene in the same amount naphta is recommended by cyb in his tek.
2.- i will evap the toluene by heat with an electric pad until there is no more solvent in it.
3.- i dont want to re-x because im looking for a full spectrum yellow orange dmt.
4.- i dont want to get poisoned or to poison my friends with toluene.

other path:

1.- use toluene instead of naphta.
2.- salt the toluene with vinegar.
3.- i dont know what to do next since i dont want to pull white xtals.

is it fine or am i losing something? can anyone help? i am planning to do this in 24 hours, if im not convinved with my knowledge until then i guess ill have to pospone this run until further investigation.

thanks in advance. cheers m8s.

I've only ever used xylene but that aside, from my experience you want to just to an STB.
Do not salt! You'll risk not getting the full spectrum.

Whenever I've pulled jungle I've done a simple STB but replaced naptha with xylene.
I'm sure toluene would be the same.

My process went:
1) Powder MHRB
2) Basify water with lye
3) Let sit for a day, shaking like crazy every few hours
4) Pull with xylene, mix in more xylene, shake like crazy, let sit for a day
5) Repeat 4 3-4 times

Make sure whatever solvent you use is clean!!!
Try evaporating some on pyrex at the very least. If you see residue left behind then you know it'll also be left behind in your final product.

Finally, don't assume your product is dry. Whenever I'd pull jungle, it would come out like a wax. The first time I ever did it I made the mistake of smoking it too soon just to taste ... xylene.

I'd suggest once it looks dry, break it up as finely as possible and let it dry an extra day then repeat the process one more time.

thanx, worked like a charm, i left it to dry for several weeks and now i have a geasy powder which is very strong and is not harss to smoke, i think is very clean.