Hello, everyone I have lurked for a long time and have just made an account. SWIM did a STB extraction with Acacia Confusa. SWIM had spent a lot of time looking for reports or anything that could tell SWIM if it worked or not. After finding nothing, SWIM decided to just go for it and hopefully give everyone else a helping hand. SWIM used a modified version of Lazymans Tek. It was the easiest one for a beginner. SWIM did the extraction normally until the evaporation stage. SWIM tried to evaporate the first pull, following instructions closely, SWIM got a very small amount of orange goo. SWIM scraped it off and tried to smoke it. It caused minor euphoria and very small closed eye visuals. This dissapointed SWIM. SWIM did another pull and instead followed the CFC method of crystallizing. SWIM was planning on crystallizing anyhow but noticed impurities and thought that would be the best method to get rid of them. SWIM checked back the next day and noticed quite a few yellow crystals had formed. They were not very big yet but looked to be growing. SWIM was wondering why they were still yellow and not white after the CFC method had been followed? SWIM thought it could be SWIM's method of crystallizing. SWIM took the naphtha and put it all in a large glass dish and left it sitting open in the refrigerator on a cool setting for an hour, then maxed out the cold for the rest of the time. When it was time to harvest the crystals, SWIM turned the temperature down for awhile so it could cool down then harvested the crystals. They were yellow and weighed out to about .65 grams. This was only from the first pull. SWIM used 250 g Acacia Confusa and 250 ml naphtha on SWIM's first pull. Was that about the average yield expected? Also, SWIM will be around for a little longer if anyone has any questions or wants to know about the first extraction SWIM did. ALmost forgot, the DMT from the first pull was quite strong and SWIM managed to break through with just .35 mg Is that normal or high/low? Thanks again everyone, peace