Hello nexians. Allow me to introduce myself, I am GoodApollo and I will be writing on behalf of SWIM.

Swim had found a tek on this forum to extract DMT freebase using the following:

900ml distilled water
40g MHRB powdered
60g NaOH
40g Crude salt
15ml naphtha per pull

However Swim supplimented the following due to lack of access:

40g crude salt - 40g sea salt
15ml naphtha - 15ml white spirit (Bartoline low odour from B&Q)

The tek also evaporated the naphtha, whilst Swim used freeze precip due to the extreme time taken to evaporate the white spirits and not really having a good space to do such.

In the tek, the member whom Swim can't remember right now stated that he was able to get
0.7g DMT freebase in total. Swim has been much less successful, extracting <0.1g. Swim would be very grateful to the nexus for any advice on how to proceed and produce greater yields.

How many pulls did you do? Maybe you should evaporate whatever white spirit you have left to see if theres any dmt in there.

Or maybe try getting some ronsonol lighter fluid and using that as your solvent. Ive never used white spirit but the thought of it makes me eewwwwww!!

You wanna use more solvent per pull, try 40/50ml per pull. How many pulls did you do?

Its also better to use swan lighter fluid than bartoline as its easier to reduced the volume which will leave you with greater saturation allowing for better freeze precip.

And stop SWIMMING, its pointless

I've done like 7 pulls altogether. Def going to decommission the white spirits. I've used some swan lighter fluid for 3 of those pulls and in honesty the spice came out a lot less pure, more yellow and nasty. I've heard that panel wipe might be the best solution. If I track some down I'll post my results. Until then I'll use ronsonol and try to vape around 50% before I freeze precip. Thanks for the help guys. And no more swimming I promise. SWIM out.