The Spice Device!I created this device out of the need for an efficient, easy and disposable way to smoke Spice. I have never used 'The Machine' but i'm pretty sure this bitchin' Spice Device is just as good, if not better.
Materials Used1 Base Pipe
1 Plastic
Poland Spring Water Bottle (20fl oz)
A Little Bit of Duct Tape
How did i make it?Step 1: Use lighter & Sharp knife to melt/cut a hole in the plastic cap. Create a hole big enough for the Base pipe to fit in.
Step 2: Place Duct Tape around the hole of pipe and cap to create an airtight seal.
Step 3: Screw Pipe onto the water bottle. (Make sure the carb is facing
down)
Step 4: Cut a hole in the
side of the tail end of the water bottle.
How do I use it?Step 1: Load Spice through the carb hole
Step 2: Shake Spice so it gathers on end of the bulb and near the carb hole.
Step 3: Hold flame under the bulb to vaporize the spice. Move the flame directly past the carb hole to force the spice vapors down the pipe and into the water bottle. Repeat as necessary.
Step 4: Stop lighting when there are little to no vapors being produced.
Step 5: Inhale all the vapors at once.
*Note: The placement of the Carb and Sucking hole is important. The carb should be facing down - holding the flame under the carb will push the vapors into the bottle to be collected. The sucking hole is conveniently placed on the side for easy inhalation.*
Also, make sure the inhalation hole is
not blocked during lighting, otherwise the vapors will not move into the bottle.
Download the videoAnd now for some pictures: