This is SWIM's first post following my first extraction attempt.

SWIM used the Q21Q21 extraction method with 50g MHRB (dye if that makes any difference)

SWIM used coleman fuel as Naphtha (in UK so don't know whats best)

So SWIM added the naphtha to the 'mhrb paste', and then poured the naphtha into a jar (glass measuring jar thingy) Then put it straight in the freezer uncovered

Then SWIM repeated three more times

SWIM started to get some nice crystals sticking the the bottom of the jars and after about 20 hours SWIM took one out of the freezer, poured the Naphtha out into a coffee filter (none of the crystals came out into the filter, they were all stuck to the jar)

After about 2-3 minutes all of the crystals had dissolved, and I was left with what seemed like left
over water. The same happened for every one of SWIM's pulls.

They definitely looked like crystals, but now I'm starting to doubt myself and maybe it was just frost ahaha.

Either way, SWIM is very disappointed and would appreciate and suggestions/feedback

<3

If you put it in the freezer uncovered then I can almost guarantee it was ice crystals. Dmt crystals wont melt at room temp. But as far as what went wrong with the tek I cant say. I use Cybs hybrid salt tek and have always been pleased.

Did you try looking at the FAQ suggestions?

Good luck!

Thanks have now had a proper read through all the different teks and the general stages. Now going to try again more informed. Probably should of done that before aha

It is hard to tell what went wrong from the info you posted. Could be high humidity, some folks struggled with a similar issue.