There are also other threads in relation to non juice atomizers.
My go to now, for every such substance, is e-mesh vaping. Take a SS316 mesh, mount it to your mod and use it in TC mode. Basically similar like conventional foil vaping, but with perfect temp control over the whole mesh and evaporation on both sides at once. Like that you can easily take even 100mg+ tokes within a few seconds, without burning anything (surface is everything, when vaping IMHO, as substances usually just don't like to be exposed to longer times of heat). I recommend about 2mg/cm2 (less is better). Don't go over 5mg/cm2
Buy some SS316 mesh band... Then use any old atomizer base, with screw terminals (e.g. I use the base of a DT V3). Then fold the ends of the foil so, that it's "wire like", so that you can screw it on this base (actually a base for mesh vaping makes it a bit easier, e.g. like the Vandyvape mesh ones). And Voila, you have yourself a TC mesh for vaping stuff...It' obvious, that the bigger you make the surface, the more power your mod needs... (but e.g. something as a 2x10cm mesh, still easily works nicely on my one battery mod).
The mesh stripes you use should be the same width throughout. Otherwise there would be temp differences due to different resistances. But if you fold it in width doesn't make any difference, as still the same metal cross section is there.
Melt the substance into the mesh on low temp (leave about 2cm distance to the electric connectors so that the substance doesn't creep in there), then set evap temp and go...
Also, as substances always have the tendency to run to the deepest point and collect there: Hold your device with you electric connectors being on the highest point.
As soon as it creeps into the connection terminals, you're screwed, as it will totally kill a proper TC functioning anymore.
The IMHO good points about this tek:
Giant evaporation surface (it evaps on both sides of the mesh), extremely fast heat up and cool down time (as almost no thermal mass) and completely even controlled temp over the whole surface (no burning of substance).
You only use quite low heat for evaporation (compared to other solutions), to prevent burning, but as you have a big ass surface, you still get a gigantic vapor production rate.
Ah, and although obvious: When you have mounted your mesh, first set to like 200C or more and go. The SS mesh will give off some nasty SS fumes. But now, it's passivated, and you can use it.
I claim not that this is the truth. As this is just what got manifested into my mind at the current position in time on this physical plane. So please feel not offended by anything I say.