Hello Hyperspace
SWIM recently attempted an extraction and got very small/barely noticeable yields. SWIM used Norman's Tek but instead of the ammonia wash used step 7 from Volvin's Tek. I have provided a link to Norman's Tek and reproduced the step from Volvin's below. SWIM hypothesizes that there are several reasons for the failure.
1) only 50 g on MHRB were used.
how much yield should SWIM have expected to get?2) the recrystalization process dissolved much of SWIM's product.
is recrystalization really worth it for a n00b to try?3) SWIM rubbed the spice from the coffee filter that was used onto some cannabis and attempted to vaporize it at setting 8 on the Volcano Vaporizer.
perhaps this was the wrong temperature? 4) perhaps combining teks wasn't a great idea.
please, if anyone has tried this combination or knows about it, can you illuminate SWIM? if not, are there any teks that are good for beginners that do NOT include a crock pot?
THANKS!
Norman's Tekhttp://www.erowid.org/pl.../mimosa_chemistry1.shtml
Step from Volvin's TekStep 7: Washing
Naphtha from step 6
Distilled Water
Sodium Carbonate
This is a somewhat new process that is not found in many of the older tek's. This
process will try to remove as many of the foreign chemicals from the naphtha
solution as possible. Especially the lye that was added in a previous step. The
goal here is to leave only the DMT in the naphtha so that when you evaporate
you end up with pure crystals.
Begin by taking about 50 ml of Distilled water and placing it into a flask and
adding sodium carbonate to it. Just add a pinch to the water. It doesn't take
much. You will only be using this mixture for the first wash. Do not use it for the
second and third washes.
A little dab will do yah here, add only a small amount of the water/sodium
carbonate solution to your naphtha. If you have 300 ml of naphtha then you want
to put around 25 ml of the sodium carbonated water. Mix the 2 together and then
place them in a seperatory funnel. Shake the hell out of it this is the only mixing
step where the liquids separate almost immediately so no worries about too much
agitation. Separate the water from the naphtha and discard the water.
For the second and third washes you want to use only distilled water nothing
should be added. 25 ml per wash is sufficient. Perform the same procedure as
above. You should not leave the water in the naphtha for too long. This means no
sitting for hours letting it 'soak' you need to get it in and out.