Ok I have done this twice in a row and got near salt dry fine crystal frost [from acrb] much dryer than what i got 10 days ago..
All you need is a fan to evaporate it..
I used no freezer or defatting but just descovered a method thanks to cybs heating and cooling method..
After using cybs heating in water bath with electric stove then letting it cool method.. As i used a fan to reduce my napatha pulls [ to create a saturated condition]..the solvent quickly became milky white.. and instead of putting in frigerator to produce crystals 15 hours overnight i did an experiment..
When the napatha was reduced ..[75 percent] [or more] I noticed a fimilliar frost on bottom of dish because the saturated napatha was crystalizing in front of my eyes..
I quickly poured the small amount of napatha barely covering the crystal frost into another jar for storage...
Then i quickly tryed to dry it to see if i would get dry crystals or sticky crystals?...
Then to my surprise after drying for ten minutes with a computer fan i tryed to scrape the frost..
It scraped up perfectly like table salt and snow white!
This ACRB exrtraction was done by simple evaporation!

I have gotten this frost before by reducing the solvent then putting it in refrigerator 15 hours overnight..but what i got was more sticky never as dry as this stuff in photos below...
I used a combination of thicklights tek.. by acid boiling the bark ..and some of cybes tek by using a hot water bath alowing it to heat and cool...
It was Cybs hot water bath method ..that i used today that helped very much!... that pulled out alcaloid rich solvent that quickly became milky white as it was being reduced by fan...
And the evaporation method surprised me a lot..because ive never produced such a white and dry velvety powder as in photos below!
What i mainly did was powdered up 100 grams acrb then did 4 hours of acid boiling...then added my ..lye salt..and napatha...
I think this will work every time by simple evaporation if your solvent pull is made saturated enough..
I think the secret was that.. as i lowered the volume of the napatha 75 percent or more..
I noticed that i was getting a bathtub ring of crystals around the inside of dish.and also compleatly covering the bottom with a crystal frost ..[as seen in photos below..]
When solvent was reduced [very low] it was barely covering the bottom of dish..
Then I quickly poured the left over napatha in another jar and put the dish in front of high speed computer fan and it quickly dryed into fine crystals that I easily scraped out without any problem ..[ver dry like table salt!!]
I think that reducing the rich solvent and quickly pouring out the napatha kept the plant oils from settling dpown into the crystals below...
Otherwise letting it sit all night might alow the oils to settle into bottom of dish sticking to crystals...
I think i removed the plant oils from crystals at right time [by pouring out beforer fan drying] alowing near pure crystals to easily dry!
This test is new to me.. and i have yet to try my product...

Just what i thought!
After putting the napatha i poured off.. [from extraction photos in post above]...in refrigeration for 16 hours overnight ..[in photo below]..there is a similar frost covering bottom of dish with very active DMT ..but it is also waxy...
So far it looks like pouring off the napatha after reducing it.....
[75 or more percent causing saturation ]...then quickly drying it produces a nice clean dry white powder that could be closer to pure DMT...
I vaped about 8mgs last night of the dry stuff and it was very effective!
photo below of poured off napatha containing some oils...

That's great, starway! I'll have to try that on my next extract experiment.

What is especially amazing is how the dmt crystallized into the smiley face pattern in the third photo, that should have been an indication right there that the gods are smiling down on you!
:

I just drew a picture in the frost.. showing how cleanly it lifted from galss...

Damn and here I was thinking that some hyperspacial entity was giving a sign,lol.

I finished the last of my acacia extraction and continue the method i talked about above using ..[evaporation and plant oil pour off method].. and its working great!
Photo below shows a small amount of spice i re crystalized and it is very fine like white flour and is very active...
Im ..[very surprised!].. at the lack of intrest in this method.. this stuff is a much dryer easy to handle and store crystal powder ..
I have percipatated mimosa in freezer before and it still is a little waxy and will melt if it gets a little too warm..thats why it needs to be in freezer for storage..
These evaporated crystals are very white and sparkle a lot..and ....
[I think it will stand way more heat!... than freeze percipitated crystals!...
any way here is photo of the last small pull from my ..100 gram acacia pull.. ive gotten over one gram crystals so farQ!