SWIM says
"The first picture is of a STB extraction after crystallizing. I used NaOH to basify and pulled with Xylene. I then simply let it dry out over a fan....
The second picture is of the collected product in its vial. Only afterwards did I realize that the XTRCT was very dirty. I tried to wash it with Na2CO3 to no avail. Whatever the contaminates were, they stayed in the xylene throughout every process.
Picture three shows HCL water being used to turn the freebase into water loving salts... The XTRACTS moved back into the bottom aqueous layer. This did the trick in separating the contaminates out.
Picture four shows the cleaner salts that I collected being turned into freebase in an aqueous solution.
The fifth picture shows the collected xylene with its much cleaner spice solute.
The sixth and last picture shows my new QUIK EVAPโ technique... (Give credit where credit is due boys) However, something went wrong. Because after the QUIK EVAPโ was done and had died out.... (In other words the xylene burned off....) There was nothing but a bunch of black nasty nonpsychoactive gunk.
My question is? Where did that come from?!?!?!? Did I make a bunch of DMT Oxide because of the heat?"
olderROM attached the following image(s):
1.JPG
(82kb) downloaded 153 time(s). 2.JPG
(74kb) downloaded 155 time(s). 3.JPG
(38kb) downloaded 154 time(s). 4.JPG
(48kb) downloaded 153 time(s). 5.JPG
(49kb) downloaded 155 time(s). 6.JPG
(113kb) downloaded 154 time(s).All of the posts made are hypothetical and for educatiunal/entertainmint purposes only. SWIM (a fictional chaaracter) and his activities are completely fictional.