INTRODUCTION
Hi all, after a long break from DMT I recently revisited its domains with a good friend of mine to re-experience its effects. I was however thoroughly disappointed with my results as they were, to say at least, lacking.
I ended up vaporizing as much as 122mg's of DMT with (IME) poor results, afterwards I asked myself why this was even though I already knew why, it was because of my poorly performed technique.
As I had not been using anything for a long time I was very anxious about the whole thing, I could only vaguely remember
how a breakthrough experience was and
what it was etc. So to make sure I was going to experience one again I loaded 122mg's like a fool, thinking that I therefore decreased chances of failure and increased my chances of reaching a breakthrough.
Now, this is the usual method I would approach, but my long time "off" DMT had made me lose my skill set in this technique to perform such a task efficiently. Which is why the heaping 122mg's of DMT gave me nothing more than a 40mg~ experience.
RESULT
When vaporizing DMT,
technique is
everything. Drug placement, vaporize the product even, perfect distance to heat, right speed of vaporization etc...
When vaporizing DMT the person should be
100% focused on his/her
technique, assuming the method is viable of course, in this case I recommend making a "Machine" as I've personally found it to be of great success and easy to use with DMT.
Secondly, the person should start low, not only for the sake of being cautious, but to mentally and physically prepare oneself for the larger volumes of smoke which, naturally, comes with the larger quantities (dosages) of DMT.
Start small in dosage in order to
master the technique, max 3 tokes, hold each for 10seconds, although no more than 10 since we want to stay in the 30second "window" while your motor skills are still functioning.
Do
NOT compensate a lacking technique with a higher dosage, don't go up in dose until you master the technique regardless of dose.
Finally, you may vaporize as much as 100mg+ assuming that it's done efficiently, max 3 tokes/10sec each, max 30s of administration. In this case, you will always be able to take more than before even though you will probably not be able to administer all of the 100mg's. The sole point of loading more is to increase the intake of DMT per toke, you simply increase the volume in order to increase the "cap".
For example;
30mg DMT, 3 tokes within 30seconds, 99% absorption.
60mg DMT, 3 tokes within 30seconds, 89% absorption.
100mg DMT, 3 tokes within 30seconds, 79% absorption.
Even though the rate of the total absorption is
diminishing , the total volume of DMT absorbed is
increased with each of the three tokes within the 30 second window, resulting in a stronger experience. This is
not a waste of product as the DMT cools off very fast and begins to re-crystallize inside the device as a form of residue.
My interest in DMT is seemingly everlasting but my ambition as a psychedelic explorer is certainly vanishing. As for DMT I will probably revisit its domain, but less frequent than before and in-between a larger time span
May your stash never grow thin nor your experiences dull!
Mad, bad and dangerous to know.
There's magic out there!