I copied and pasted this as to not link the nexus to the source which happens to be January-December 2007 microgram journals at the DEA website.
So I agree no youtube videos are needed but dont kid yourself into thinking that the DEA doesnt know about MHRB because its right there in black and white.....They know!!!
The Isolation, Identification, and Quantitation of Dimethyltryptamine
(DMT) in Mimosa hostilis
Jack A. Fasanello* and Andrea D. Placke
U.S. Department of Justice
Drug Enforcement Administration
Northeast Laboratory
99 Tenth Avenue, Suite 721
New York, NY 10011
[email: jack.a.fasanello -at- usdoj.gov]
[Presented in Part at the 33rd Annual NEAFS Meeting, Bolton Landing, NY,
October 31st - November 3rd, 2007.]
ABSTRACT: Dimethyltryptamine (DMT) was extracted from the root bark of Mimosa hostilis via three methods, using methanol (direct or via Soxhlet) and acetic acid (direct only), respectively. The product from the direct methanol extraction was used in both qualitative and quantitative analysis, while the product from the acetic acid extraction (isolated in crystal form after workup) was used for qualitative analysis. FTIR/ATR, GC/MS, GC/IRD, 1H-NMR, and HPLC data are presented. Quantitative analysis by 1H-NMR and HPLC indicated 0.9 percent and 0.8 percent DMT, respectively, in the analyzed samples.
KEYWORDS: Mimosa hostilis, Dimethyltryptamine, DMT, Extraction, Analysis, Forensic Chemistry
Introduction
Tryptamines are substituted indole compounds which are both naturally occurring and synthetically manufactured. Many tryptamines, including dimethyltryptamine (DMT, Figure 1), have hallucinogen properties, and are therefore listed as Schedule I drugs under the U.S. Controlled Substances Act (21 CFR 1308.11). DMT is present in many plants and their seeds, including in Mimosa hostilis and Psychotria viridis [1-3], and can be abused by smoking, injection, or ingestion of either these natural materials or their crude or purified extracts, either alone or in combination with other extracts (e.g., Ayahuasca [4].) Mimosa hostilis and similar natural plant materials are not formally controlled (by name) in the United States; however, they are controlled (Schedule I) if they are shown to contain DMT or other controlled hallucinogens. Despite their controlled status, a number of DMT-containing natural products, including Mimosa hostilis, are openly marketed on the Internet.
Figure 1. Structure of Dimethyltryptamine (DMT; C12H16N2, m.w. = 188.27).
Clandestine DMT extraction laboratories are occasionally seized by law enforcement agencies [e.g., 5]. The basis of this report was the seizure of an unknown plant material (Photo 1) at a clandestine MDMA (Ecstasy) laboratory in rural Pennsylvania. GC/MS analysis of a methanolic extraction of the material identified DMT. Upon debriefing, the defendant in the case indicated that material was root bark from Mimosa hostilis. Similar seizures of this material have been made at other clandestine laboratory sites in the United States, and subsequent analyses of those exhibits confirmed that they also contained DMT.
Photo 1. Mimosa hostilis Root Bark Seized at Clandestine Lab in Pennsylvania.
Experimental
Methanol Extraction: The root bark was cut into small pieces then ground in a blender to produce a very fine powder. For direct extraction, methanol was added to the powder, heated to 60°C with stirring for 1 hour, and then filtered. This step was repeated three more times, except the re-extractions were carried out for only 5 - 10 minutes each. The combined extracts were evaporated to a residue over steam, then reconstituted as needed for analysis. For Soxhlet extraction, the powdered material was placed in an extraction thimble, placed in a Soxhlet, and extracted with 50 mL of methanol for approximately 50 volumes. The solvent was evaporated to a residue over steam, then reconstituted as needed for analysis.
Acetic Acid Extraction: The root bark was cut into small pieces then ground in a blender to produce a very fine powder. A 3% acetic acid solution was added to the powder, and the resulting suspension was stirred for approximately two hours. The solution was filtered and transferred to a separatory funnel, made basic with sodium hydroxide, and then extracted with methylene chloride. The methylene chloride solution was isolated, and the aqueous later was re-extracted with a second volume of methylene chloride. The combined extracts were dried over magnesium sulfate, filtered, and evaporated to give a crystalline material.
Fourier Transform Infrared with Attenuated Total Reflectance (FTIR/ATR)
Instrument: Perkin-Elmer Spectrum One FTIR.
Data collection: Four scans were collected between 650 cm-1 and 4000 cm-1.
Resolution: 4 cm-1.
Sample: Crystals from the acetic acid extraction.
Gas Chromatograph/Mass Spectrometer (GC/MS)
Instrument: Agilent 6890N GC/Agilent 5973 Mass Selective Detector.
Column: HP-5, 30 m x 0.25 mm x 0.25 μm column.
Temperature program: 90°C - 120°C @ 35°C/min; initial time 1.35 min, then 120°C - 290°C @45°C/min; initial
time 0.55 min, final hold time 8.5 min.
Injection port temperature: 300°C.
Transfer line temperature: 280°C.
Ionization source: Electron ionization (EI).
Mass analyzer: Quadrupole.
Scan range: 40 - 525.
Quadrupole temperature: 150°C.
MS source temperature: 230°C.
Sample preparation: Residue from the methanol extraction, reconstituted in methanol.
Gas Chromatograph/Infrared Detector (GC/IRD)
Instrument: Agilent 6890 GC/Varian IRD Detector.
Column: HP-5, 25 m x 320 μm x 0.52 μm column.
Split mode: 5:1.
Temperature program: 100°C for 1.50 min, ramp @ 35°C/min to 120°C, hold for 0.55 min, then ramp @
40°C/min to 290°C, final hold for 8.13 min.
Inlet temperature: 270°C.
Injection volume: 2 μL.
Constant column flow: 2.0 mL/min.
Transfer line temperature: 280°C.
Flow cell temperature: 280°C.
KBr windows.
Optical resolution: 8.
1.5 scans/sec.
Sample: Residue from the methanol extraction, reconstituted in chloroform.
Proton Nuclear Magnetic Resonance (1H-NMR)
Instrument: Mercury 400 MHz.
Number of transients: 8.
Relaxation delay: 45 seconds.
Pulse: 90°.
Sweep width: 6393.9 Hz.
Temperature: 25°C.
Sample preparation for qualitative analysis: Crystals from the acetic acid extraction, reconstituted in 1 mL
CD3OD.
Sample preparation for quantitative analysis: 5.0 g Mimosa hostilis extracted via the methanol extraction
procedure, yielding 1.52 g residue. Added 28.0 mg to 1 mL CD3OD, with 5.544 mg maleic acid added as the
internal standard.
High Performance Liquid Chromatography (HPLC)
Instrument: Agilent 1100 Series HPLC.
Column: Phenomonex Partisil 5 μm ODS-3 (C-1
.
Mobile phase: Phosphate buffer pH 2.5:methanol (90:10).
Injection: 5 μL.
Flow rate: 1.0 mL/min.
Detection: 280 nm.
Run time: 8 minutes.
Sample preparation: 9.9 g Mimosa hostilis extracted via methanol extraction procedure, with the residue
reconstituted in 100 mL methanol.
Results and Discussion
The extraction of DMT from Mimosa hostilis was completed using two different solvents, methanol (direct or via Soxhlet) and acetic acid (direct only). The methanol extraction gave the maximum recovery of DMT for qualitative and quantitative analysis; however, the extract included other soluble plant impurities. The extraction efficiency using methanol was identical whether done directly or via Soxhlet. The acetic acid extraction gave a very clean, pure product, but in lower yield versus the methanol extraction.
FTIR/ATR: The crystals from the acetic acid extraction procedure produced a clean spectrum (Figure 2).
GC/MS: DMT eluted at 6.06 minutes using the described method. The spectra showed a base peak at m/z = 58
and the molecular ion at m/z = 188, along with smaller peaks at m/z = 44, 77, and 130 (Figures 3 and 4).
GC/IRD: DMT eluted at 6.88 minutes using the described method (Figure 5).
1H-NMR (Qualitative): The singlet at 2.35 ppm is due to the two N-methyl groups, the two triplets at 2.70 ppm and 2.95 ppm correspond to the alpha and beta methylene groups. The multiplet at 7.00 ppm corresponds to protons 2, 5, and 6 on the indole. Finally, the two doublets at 7.25 ppm and 7.50 ppm correspond to protons 4 and 7 on the indole. A slight shift was observed in the extract versus a DMT standard; this was due to pH differences (the spectrum was obtained from DMT acquired using the acetic acid extraction procedure, which involved an acid base workup). (Figure 6). (Qualitative): Using the direct methanol extract, DMT was determined to be 0.9% weight/weight in Mimosa hostilis (Figure 7 and Table 1). Using the direct methanol extract, DMT was determined to be 0.9% weight/weight in Mimosa hostilis (Figure 8 and Table 2).
HPLC: DMT eluted in under 3 minutes. Using the methanol extract, DMT was determined to be 0.8% weight/weight in Mimosa hostilis (Figure 9 and Table 3).
Acknowledgments
The authors would like to thank the Laboratory Director Thomas Blackwell, Supervisory Chemists Christopher Guglielmo and Ann Marie O’Neill, Senior Forensic Chemist Michelle Camilleri, and Forensic Chemists Christopher Benintendo and Ken Fuentecilla (all of this laboratory), and Senior Forensic Chemist Patrick Hays (DEA Special Testing and Research Laboratory, Dulles, VA).
References
1. Duke JA, Vásquez, R. Amazonian Ethnobotanical Dictionary. CRC Press, Boca Raton, FL:1994.
2. Schultes RE, Hoffmann A. The Botany and Chemistry of Hallucinogens, 2nd ed., Charles C. Thomas, Springfield, IL:1980.
3. Blackledge RD, Taylor CM. Psychotria viridis - A botanical source of dimethyltryptamine. Microgram Journal 2003;1(1-2):18-22.
4. Casale JF, Koles JE. Analysis of ayahuasca (“Santo Daime”). Microgram 1995;28(9):296.*
5. Anonymous. Clandestine dimethyltryptamine (DMT) laboratory seized in Hollywood, California. Microgram Bulletin 2007;40(7):65-6.
* Law Enforcement Restricted Publication.
"Keep your friends close and your enemies dismembered."
Lowjackal original quote