Late reply, my apologies.
First of you will need to test if your 5meo is freebase or salt. I noticed some suppliers sell the salt form without information. Add some in water. If it doesn't dissolve it's freebase, if it does it's salt. The salt vapes at a higher temp, the freebase at a lower one.
Settings for freebase 5meo-DMT:
Use temp control and lower the temp all the way down to 100 C.
Don't use the default SS preset, use the manual mode set to 105 TCR.
See:
Quote:I carefully pulsed the ethanol dry then vaped the 5meo at 100 C. 100 C was lower than expected. I first tried 150 C, too high, 130 C still too high: harsh white smoke, while at 100 C zero smoke (pure evap) and a much better /clearer effect.
https://www.dmt-nexus.me...p;m=1085157#post1085157
Not sure if later tweaked the TCR a bit to give even lower power than the usual 105 for stainless steel. You will need to experiment by adding some powder on the mesh and hitting the fire button while blowing on it to see when it start to evap.
Note:The e-mesh is very efficient.
7mg is all you need! Big difference between 5 and 7mg so use a precise and reliable scale.
Don't vape 5meo alone! Have a sitter watch over you and observe that you continue breathing comfortably.
Good travels
some = one | here = some | there = one