I found these past posts ..below..and wanted to add my idea to this problem of putting liquid tincture in grain alcohol onto screen mesh...
#42



Posted : 6/9/2020 7:57:32 PM
QUOTE

💖

Chemical expertSenior Member

Posts: 2147
Joined: 11-Mar-2017
Last visit: 18-Apr-2021
Location: 🌎
Quick question and sorry of this has been answered already.

To make the e-mesh easier to load, could one make a ~1:9 DMT:everclear solution? Idea is that one drop (~0.05ml) has ~5mg of DMT. At 100C (or after a brief pulse) the everclear would evaporate quickly and leave the DMT behind. One could measure the dosage with drops (in ~5mg increments).

Anyone try this? Would it be easier to load drops on the mesh so DMT doesn't end at the bottom of the RDA?

Thanks
“... (a) psychedelic substance occasionally causes psychotic behaviour in people who have not taken it.”
Excerpt from a McKenna talk transcript / audio.

downwardsfromzero
#43
Posted : 6/10/2020 1:00:33 PM
QUOTE

Peeing into the abyss

Chemical expertSenior Member

Posts: 5552
Joined: 30-Aug-2008
Last visit: 16-Apr-2021
Location: square root of minus one
Loveall wrote:
Quick question and sorry of this has been answered already.

To make the e-mesh easier to load, could one make a ~1:9 DMT:everclear solution? Idea is that one drop (~0.05ml) has ~5mg of DMT. At 100C (or after a brief pulse) the everclear would evaporate quickly and leave the DMT behind. One could measure the dosage with drops (in ~5mg increments).

Anyone try this? Would it be easier to load drops on the mesh so DMT doesn't end at the bottom of the RDA?

Thanksl



My solution....
Is to dropper some spice tincture ... [at least acacia tincture]... [into shot glass alow the alcohol to evaporate...

And after an hour or two....there will be a thick dmt oil in bottom of shot glass .



Then let the oil dry several hours longer or over night ... after drying longer ..the oil will get thick and waxy...then you can use a dab spoon and take a chunk of it and place it onto the mesh pad...

When heat is applyed...It will melt and vaporize great!... just as easy as crystals!

I have a wax material from acacia confusa which would lend itself nicely to being buttered onto an emesh without spilling. It is just acacia confusa goo dried and cured.

For shure! It should work great that way!