Measure out 50ml of naphtha (lighter fluid) and pour into the bottle.
Lightly shake and roll the mixture in a 'figure of 8' fashion (or like peddling a bike) for 20-30 seconds.(The idea is for the naphtha to 'touch' every part of the base mix)
Unscrew the cap momentarily to release any pressure build-up then tighten again.
Place back in a heat bath. (Heated pulls draw more product)
Leave for a while until the naphtha separates again. (edit: This has been reported to take an hour or so the first time (occasionally))
REPEAT THIS four times (shake/separate) to thoroughly mix them together. This should take around 45 mins.

We are mostly working with freebase DMT in a naphtha/water system. We do this by attempting to decrease the solubility in the water layer while increasing the solubility in the naphtha layer.
How can we do this? Well heating the entire solution will increase the solubility in both layers, to different extents, but the bottom line here is that you want the bottom layer to be cool when your pulling the spice from it, so if you’re going to use temperature your best option is to heat the naphtha before adding it to the cool (room temp) water and mixing as much as possible before the temperature equilibrate (which happens within seconds).

Either will get you the results you are after.

MAX ION uses every trick available to squeeze every last drop out of the bark.

If you are not too worried about tiny amounts of difference...go with the original tek...its just quicker.