I came across an extract using ACRB from a new source and began today ioassaying the results, just one test so far at just above threshold levels. It produced a body high of immense euphoria, that spread through the body from the center, radiating down the extremities. It could be likened to the feeling of an opiate high, but without those substances attendant mental fogging and warmth. Also, anti-social, not wanting any human contact. Still feeling it almost thirty minutes later, pulling back into a ball near the base of my spine. I guess that's the belly chakra? Small, cold, steel blue light. This dose was smoked on weed in a pipe, probably burned. It was just a bit of the oil that is the result of the less than ideal extraction. The dose did not produce.OEVs, just the body high I'd call it instead of-load.

The extraction process I heard, went something like this: The powdered ACRB was done with the first boil when it was realized that the filtering equipment had disappeared from this reality, so an attempted decanting of the soup into the reducing pot was attempted. An amount was spilled as a result, and significant amounts of mud was being transferredwith the liquid. So more water was added to the first put and a dash of vinegar, and one more, two hour boil was preformed. The soup was transferred to the reduction pot, with a good portion of mud, and reduced to 1/4 gallon. Basified with lye and pulled with VM&P Naphtha. The pulls were VERY yellow. No de-fat was performed. They've never been necessary, but several things are different than usual here. One, ronsonol has always been the go-to nps, and two, powdered instead of finely shredded whole bark was used this time. There was no crystal formation, but the solvent was evaporated at room temp. There is clear goo in a thin layer all around the evap jar a little bit of light yellow oil, and a large amount of dark oil that dries very thick, but still liquid. This oil was what was bioassayed.

My assumptions are DMT,MMT and oxides, with some MAOI ability, (still feeling am hour later), in a matrix of a lot of plant fat. Not pretty, not at all, but the plan for it has always been to solve it in ipa, and evap-saturate mullien with it anyway. I think it can be entheogenic, forthcoming experiments will determine dosage. Unfortunately, no more time can be taken off to take off, so those will have to wait.

I know oils are often encountered with ACRB, Previous extracts with shredded bark and ronsonol have yielded lots of clear goo, amber wax, and melty crystals, from cloudy clear Naphtha, both yellow pulls and this oil never have. Which step, or misstep, was most likely the culprit. I'm a little unclear on the differences between VM&P and lighter fluid Naphtha, is the lighter fluid mute selective? Is it the powdered bark?