Hi all.

I have about 50 grams of yopo seeds. I would like to do an extraction because I am not fond of nasal administration.

I found the following posted on another forum:

Jorkest's D-Limonene Bufotenine Extraction(5-HO-DMT)

The following is a straightforward, step-by-step outline for the simple and effective extraction of the psychedelic substance, Bufotenine, from Cebil seeds. Dangerous solvents(still flammable!) are not used, and there is no danger of contamination of the final product as the primary and final solvent is 100% safe to ingest. The only strong/noxious fumes to contend with during the process are those of Acetone, unless you consider the smell of oranges from D-limonene to be noxious.

If followed with attention to detail, this extraction guide will produce approximately 1000mg of relatively clean, crystalline Bufotenine freebase powder, tan in color.

Materials:
50g Anadenanthera Colubrina (seeds)
27g of Sodium Carbonate
1g(excessive but better safe than sorry) Fumaric Acid
100ml D-limonene
800ml Acetone

Equipment:
Hotplate
The Herbal Percolator
Cotton Balls
HDPE/Stainless/Glass Containers
HDPE/Stainless/Glass Dishes

Procedure:

Step 1 ) Coarsely grind 50g of seeds into a powder, which contains the Bufotenine in a salt form; convert this to its freebase form by adding 25g of Sodium Carbonate and just enough water to wet the combination into a thick, pasty consistency. Stir this for 5-10 minutes, then dry completely.

Step 2 ) Take the freebased seed powder and add it into the THP over the cotton ball filter. Pour 200ml of Acetone over the seed powder, which will filter through the cotton and into a container of your choosing. Take that very same Acetone and pour into the THP 10 more times(its quick so might as well do it a bunch). Put the filtered Acetone into it’s own container. Take 200ml of fresh Acetone, and repeat another 10 filters, adding that to the previously filtered Acetone. Once more, take another 200ml of fresh Acetone, and filter 10 times, adding it to the mix. You should have approximately 600ml of Acetone which has been run through the ground seed powder many times.

Step 3 ) Prepare your FASA* by adding your 1g of fumaric acid to 150ml of acetone, and stir. Add the FASA* to the 600ml of filtered Acetone, for the Bufotenine to fumarate salt conversion, which will settle to the bottom. Continue adding FASA* until clouds no longer form in the mixture. Pour out the Acetone/FASA* mixture after all solids precipitate and keep the left-over solids.

Step 4 ) Convert the left over solids back to Bufotenine freebase by adding a spoonful(2g) of Sodium Carbonate and just enough water to turn them into a pasty consistency. Dry completely.

Step 5 ) Pour 50ml of fresh Acetone into the Bufotenine freebase and stir for 5-10 minutes; when done, pour the Acetone through a cotton filter into a glass dish to allow for it to evaporate over a hotplate. Do this twice with a fresh 50ml of acetone. This should recover approximately 2g of Bufotenine freebase.

Step 6 ) Bring 35ml(more than you need but quite a bit of it evaporates during the boil) of D-limonene to a boil (176 Celsius) and then add the Bufotenine freebase. The D-limonene will be hot enough so that the Bufotenine will melt and become soluble in the hot limonene, but the toxins and other undesirables will not be, and will remain. Let the mixture boil for 5 minutes.

Step 7 ) Pour off the boiling D-limonene into a dish with a large surface area so that it can cool. When pouring off the D-limonene you have to wait until it stops boiling, this only takes like 5 seconds because otherwise the contaminates do not puddle up. After it stops bubbling immediately pour it off because it is starting to drop the bufotenine. As soon as the D-limonene cools below it’s boiling point, Bufotenine freebase will quickly fall out of it; emphasis on quickly! It happens in mere minutes. Allow the D-limonene to continue to cool completely and then pour off the remaining clear d-limonene. You should be left with approximately 1g of Bufotenine freebase, allow residual d-limonene to evaporate off, using a slightly warm hotplate speeds this up greatly.

Step 8 ) Repeat steps 6 and 7 again on the black goop that is left after the first d-limonene boil. This will get out any left over bufotenine.

Step 9 ) You can then repeat the d-limonene boil on the already purified bufotenine to purify it further.

Step 10 Enjoy!


Swim (fatcat) did not make this TEK, it was made on another forum, but he has used it and can confirm its reliability, and the awesomeness that ensues.


* FASA= Fumaric Acid Saturated Acetone, but swim has done it with Citric acid, and it works, but not as well

also calcium hydroxide works instead of sodium carbonate. Not too sure about sodium bicarbonate though.


Read more: http://www.drugs-forum.c...hp?t=83773#ixzz2WPuYPnCQ

Anyone have experience with bufo extraction from Yopo seeds?

peace

Intetested in doing this extraction and making a nasel spray solution. Instead of snuffing dry powder yopo could do a few quick pumps of the solution. Would be intetested in making DMT nasel spray too.