SMOK X-Priv 80W Baby Kit for vaping?
Hi im thniking of getting SMOK X-Priv 80W Baby Kit for vaping dmt,will this be a good option and if not why?

Logically, all you need to do is think of what's needed to vaporize DMT or anything in general?

Pretty much, all that's necessary is a vessel of some sort and a source of heat that's not too low or too high.

You can vaporize DMT with essentially anything that fills those requirements. With that said, some options are easier/well-tested than others; as long as you are able to vaporize it at the right temperature, all should be fine!

You will need to dissolve the DMT in a mixture of PG/VG and find a ratio that will do what you are looking for. It's relatively simple for most people, place the crystals in a shot glass with the PG/VG mix and place in a heat bath while stirring until dissolved.

Sub-ohm tanks are great for bringing in more vapor in a shorter amount of time, but not necessary like many claim. (If you have a high ratio of crystal/PG/VG that's stable, you should have no problem getting the dosage in time)

You should also double check if it has a SS316 coil for TC or you may want to purchase one to use with it.

Yes it would work, but you should be aware of what to look for in an atomizer for DMT. I was dead set on making DMT eliquid work for us. Our experience is with the Smoalk "Big Baby Beast" (BBB) which appears similar to the one you are looking at. We had fantastic experiences with it at first, but eventually saw many drawbacks/hurdles. I'm still convinced that it is an ideal way to smoalk, so hopefully these tips will help.

Have you figured out what concentration you want to make the eliquid? You don't need a really powerful atomizer to get a good hit. Our eliquid was a very high concentration - around 1g DMT/1g PG/1gVG. This paired nicely with a M2 .25 ohm coil - the smallest you can buy from Smoalk. It hit the sweet spot around 20-25w, and 1 single inhale could send most people to an instant breakthrough. I imagine that any atomizer with a nominal 50w would be ideal. No need to blow clouds unless you're into that.

The two main flaws that we experienced are severe leaks, and inconsistent hits. The BBB never leaks with normal eliquid, but I found out the hard way that it likes to waste DMT. To start, we stored it upside down to prevent leaks. Unfortunately, juice will run down from the cotton over time, and you'll lose your precious golden nectar. When stored upright, it will leak given enough time. Atmospheric pressure changes, and temperature changes cause it to slowly leak out. Whatever you do, don't drive over a mountain, or the elevation change will force all of the juice out. Usually the inconsistent hits went like 1st person gets cannon balled into hyperspace, but each person after that gets less of an experience. It really was a downer when trying to share. That first hit was always fantastic, and very strong though! The flavor starts to go off very quickly with these coils. I think it starts to burn the DMT over time, and it tastes horrible.

At the moment, we are re-evaluating the vaping method. I purchased a ceramic doughnut atomizer that some have raved about. It works, but it definitely isn't as smooth, and you just can't get as much DMT as quick as you can with eliquid. I think when we go at it again, we will do away with the tank idea all together. I honestly think that an RDA would be much more suitable for this purpose. It would give better control over each hit, and probably eliminate the leak problem. I haven't tried it yet, but "The Maze" really caught my eye. It has a gimmicky flat coil that is unique for an RDA, and minimal cotton. This doesn't really do anything for us nicotine vapers, but it appeals for DMT due to the minimal wicking material. I think this would be ideal to prevent leaks, and to meter the dose better. The reviews are mixed for normal vaping (something about dry hits), but I think it should produce good hits if you drip just what you need on it. The only downside for me is that it's designed to run at a higher wattage (50-100w). This could be adjusted by making the DMT eliquid slightly less saturated. I bet it would run just fine at 40w.

Hope this helps!

These guys seem to know more about how to use a vape for this than I do.

I'll just throw in my two sense lol.

And that would be use a different product t than SMOK....

SMOK is not a good device imo.

My roommate begrudgingly carries SMOK coils at his shop because of the high demand but refuses to sell their devices haha

just to pipe in here

i agree with the leaking issue...i've had some bad luck with SMOK products leaking badly, even without spice-infused juice.

i have had fantastic success with the Uwell Crown mini. i like a tank with a small capacity so i don't have lots of juice in the tank just sitting (or leaking!). it's a 2ml tank - just perfect. never leaked a drop. solid build, great coils and reliable. pretty colors too, if that's your thing...

cheers

To chime in as well. Leaking as you have said is usually due only to the tank, many of which are easily swappable if you find one faulty.

It's going to come down to price/style at the end of the day; even if the stock tanks leak, you may still want the same battery and purchase a tank separately.

Is that the crown mini 3 mate

any of the crown minis - or any crown for that matter; i just like the mini because of its smaller capacity and size.

One way around a leaky tank is to get a rda/rdta and just drip your juice. You mathemetize it all down and get an approximate per drop idea of spice amount. No leaking, more precise hits (which isn’t really an issue once you have a feel for your juice), and you keep all your valuable juice directly at the coil. Do like a 4 wrap quad fused clapton and snip the cotton so the end is right at the ends of your coil. You probably know this but for anyone reading, turn your wattage down loooow, way low to where it’s just barely putting out what you need still cold. And be careful vapes are no joke at all.