I was wondering if Low Oder Mineral Spirits is a suitable substitution to naptha in the Norman Tek? Would I still be able to freeze precipitate out the DMT Freebase in the end?
|
|
|
I have never heard of it. Is it a non-polar solvent? All illegal narcotics are medicinal. Boredom is a disease worse than cancer. Drugs cure it, with little or no side effects if used as directed - Doug Stanhope.
Rightful liberty is unobstructed action according to our will within limits drawn around us by the equal rights of others. I do not add 'within the limits of the law' because law is often but the tyrant's will, and always so when it violates the rights of the individual. - Thomas Jefferson
|
|
|
I think so, here is an article i found about the specific ingredients of both http://wiki.answers.com/...l_spirits_the_same_thing not sure about its validity though. From what I can gather, the DMT Freebase will be soluable in the Low Oder Mineral Spirits (to what extent, I'm not sure) but I am worried that the DMT will not freeze precipitate out of the solution. Does anyone have specific experience using Low Oder Mineral Spirits?
|
|
|
I've never used it, but it has been reported that DMT is even less soluble in odorless mineral spirits than it is in naptha, so it should freeze precip really well if you can get the alks into it in the first place. It might be good for heated pulls, I don't recall anyone trying that. Forget about evaporating it - it'll take forever.
|
|
|
DMTer wrote:I was wondering if Low Oder Mineral Spirits is a suitable substitution to naptha in the Norman Tek? Would I still be able to freeze precipitate out the DMT Freebase in the end? There should be a thread on this from long long ago. Pics of xtals posted from Low Oder Mineral Spirits. never tried myself its properties did not seem conductive for my purposes. PEACE MV
|
|
|
i havnt tried barolotine low oder spirit. But i have tried b&q white spirit, which is a turpintine substitue. Its a heavy form of naptha. Its troublesome after freeze precipitation, which iave had no problem with. The first 2 pulls of 150ml left the bottom and sides of my collection jar complelty covered in crystal.
After pouring off all the solvent, enough remained on the crystals that once it warmed up it would disolve the dmt again and you'd have to evaporate the rest. Evaporating white spirit takes ages.
I improved slightly by draining of as much of the solvent, then putting it back in the freezer for 12 hours to get more solvent away from the crystals then once out leaving it upside for a few hours. then turning it right way up to evap the rest away.
I dont know if the low oder stuff is any easier to evap. If you have a fan, use it as that should help evap the white spirit quicker.
With my pulls i didnt evap any of the solvent, just straight into the freezer and 12 hours later, jar full of crystals. The colder the better, ive seen the best results with very very cold. 1 person on another forum reported upto 2% yeild of pretty clean crystals usijng a freezer that was -20c.
|