When I first started smoking dmt I had a vapor buddy and I would load it with parsly on the bottom with 30-40mg of freebase and it'd work so well , then I tried and still do and prefer enhanced leaf ratio 1:1 so why is it so that if I used to vape the above dose it's work but if I loud 150mg - 75mg E/L it does jack removed but if I load 220mg - 110mg E/L I get a breakthrough just about every go , so why is it that with the E/L I need so much more of a dose ,, does anyone else find this ??

Perhaps oxidation takes place a little faster with the enhanced leaf?

You should add some freebase harmalas to your blend.... you can slowly get to where you want to be. There's no reason for someone to not be able to break through with actual changa. Enhanced leaf can be tricky.

hoc quam verum sit

True dat !! Parshvik

Or... try putting 40-50mg of harmalas under your tongue, and then proceed to smoke your DMT-eLeaf.


How long are you holding in the smoke for Earthwalker?

I'm wondering... when you smoke freebase, it's pure DMT smoke in your lungs getting absorbed. With eLeaf however, you have DMT smoke, plus the smoke from whatever herb/leaf you are using. It would therefore make sense IMO for the DMT smoke to take longer to be absorbed by your lungs, and thus not getting in as much as you would when vaping freebase in the same time window...

This is purely a hunch and not based around any science. I'm not sure of the efficiency rates between vaping freebase DMT vs DMT that is in a salt form... I'll do some searching...