I'm a regular dmt vaper but have found recently that I get a bit of a sore throat and cough after. This applies to both e-cig and VaporGenie methods. I've decided therefore to go for plugging it for a while (rectal administration!).

I was going to follow one of the standard methods using acetone and fumaric acid to make dmt fumarate. Acetone I already have and the latter I've ordered online but as I live in a far away and backward country it's not going to arrive for two months and I'd really like to make something sooner!

Can anyone suggest an alternative? I'm not sure why any old water soluble salt of dmt wouldn't work but there must be some good reason fumarate is generally used.

Out of interest last year I did dissolve some dmt in white vinegar and evaporate off excess liquid to get what must of been dmt acetate. I dissolved it in water and tried plugging it. Even a dose equivalent to 60 mg of dmt only produced mild visuals - maybe equivalent to 12 mg vaped - so I'm guessing the dmt acetate route is not very effective.

You can go for citric acid, dissolve dmt in acetone, dissolve citric acid in acetone, drop stepwise the acetone into the citric acid till no more clouding appears.

The precipitates will be dmt citrate. Take the precipitates out dry them to some extent, dissolve in small amount of water and plug it.

DMT citrate will be very hygroscopic and will not dry to a powder. It' be a goo or a gum. Will be difficult to weight, but not impossible.

Good luck!

Any idea why the fumarate salt is generally used?

Any idea why my dmt acetate seemed so weak when plugged?

Thanks!

DMT fumarate typically forms better crystals than other salt forms. Fumarate, as an anion is very well tolerated in the body.

Possibly it was diluted with sodium or calcium acetate, or perhaps it was a biacetate, with only half the requisite amount of DMT - maybe both.
It could also be less well absorbed than other salts, or "the moon was in the wrong sign".