Hello everyone! SWIMs about to start an extraction in a few days. SWIM plans on doing an A/B up through the basification step.
But moving on to the next steps after base.. I just want a few opinions from other SWIMs that have done this to see if I got the right numbers for my fumaric acid/water mix. And also the amount of D-Limo pulls & FASW pulls...would the number of pulls SWIM stated work well enough to get most of the dmt out?
I know the BLAB tek was just created and it doesnt require the acid cooks and is much easier. But SWIM still wants to try this out and he currently has all the stuff for his d-limo/FASW.
RESPECT n' COMPASSION
COOK
1)Premix in an empty 1-Gallon jug: 1-Pint White Vinegar & 3-1/2 Quarts Water. Put the ground up MHRB in a 3-Liter crockpot, then fill it with 1/3 the water/acetic acid solution.
REPEAT 2 MORE TIMES
2)Decant all (3) 2 hour acid soaks and save in jug. Let sit overnight to allow particles to settle.
NEXT DAY DECANT INTO GLASS JUG
BASE
1)Add 70g NaOH to 1 pint warm water. Mix well so saturated. Add NaOH/water solution
to MHRB mix slowly. Test for pH of 13.5.
NON POLAR PHASE
1) Add 150ml D-Limonene to MHRB/NaOH mix. Tilt end over end for 5 minutes.
2) Pull D-Limonene and put in container.
3) Mix 650mg fumaric acid with 100ml water. Saturate thoroughly. Add FASW slowly
to 150ml of D-Limonene. MIX VERY WELL FOR 10 MINUTES FOR EACH INDIVIDUAL FASW SALTING.
4) Decant bottom FASW layer into pyrex.
4) REPEAT STEPS 1-4 three more times.
DRY
1) Combine all 4 FASW pulls in pyrex dish. Evap in dehydrator at 155 degrees for 2 days or so.